COATED ABRASIVES / 59 www.flexovit.com INDUSTRIAL LINE FX672 • Sharp zirconia grain provides a high cut rate when used under medium pressure • 0,8mm thick fibre backing provides durability and supports strong metal removal on heavy duty applications • Excellent price vs. performance ratio on metals including steel and inox • Ceramic micro-fracturing grain for a better cut rate and longer disc life • Stronger fibre backing provides better face-to-surface grinding and resists tearing in heavy-duty applications • Specially designed for use on carbon steel, indicated on the back of every disc, for easy disc identification NEW MEGA-LINE BLUE FX888X DIM DxB (mm) GRIT PK QTY ART NO. 115 x 22 36 25 78072749571 50 25 78072749590 60 25 78072749591 80 25 78072749592 125 x 22 36 25 78072749593 50 25 78072749597 60 25 78072749599 80 25 78072749600 150 x 22 36 25 78072749601 180 x 22 36 25 78072749602 50 25 78072749603 60 25 78072749604 80 25 78072749605 DIM DxB (mm) GRIT PK QTY ART NO. 115 x 22 24 25 63642585560 36 25 63642585564 50 25 63642585567 60 25 63642585569 80 25 63642585570 120 25 63642585572 125 x 22 24 25 63642585574 36 25 63642585575 50 25 63642585581 60 25 63642585582 80 25 63642585583 120 25 63642585585 180 x 22 24 25 63642585586 36 25 63642585587 50 25 63642585589 60 25 63642585590 80 25 63642585591 120 25 63642585594 TECHNICAL INFORMATION Using a fibre disc with supersize treatment is not necessary on carbon steel as less heat is generated than that produced on stainless steel. SAFETY TIPS • Fibre discs must be used with the correct sized back-up pad. The diameter of the disc must be at least 3mm but not more than 15mm greater than the diameter of the back-up pad. • Make certain that both the disc and the back-up pad are fitted correctly to the machine spindle. • Do not use a fibre disc which is damaged in any way. Always check visually for damage before use. • The maximum peripheral operating speed of a fibre disc is 80m/s. This is shown on the box label. • The fibre disc should only be brought into contact with the workpiece when the machine is running at its operational speed. The disc should be applied to the workpiece at the shallowest angle possible – about 10 degrees is recommended. • Do not attempt to use a fibre disc for slot grinding, cutting off or wet grinding. • After use the angle grinder should be stored with care. The face of the disc must not be in contact with the bench or floor. COATED ABRASIVES
RkJQdWJsaXNoZXIy MTM0NjUyNQ==